GLOCKMEISTER
PRESENTS

MAGAZINE CATCH
REMOVAL

ALL WORK ON GLOCK PISTOLS SHOULD BE PERFORMED BY A GLOCK CERTIFIED ARMORER - WITHOUT EXCEPTION.

Use a screwdriver to push the magazine catch spring out of the magazine catch groove . Be sure to press the right side of the magazine catch with a finger to prevent the magazine catch from moving when starting to push the magazine catch spring out of the groove.

Start with the screwdriver (small bladed) to the left of the magazine catch spring (see figure 1). Push the spring to the right and then pry it out of the groove located on the bottom of the magazine catch (see figure 2). It The spring should be completely clear of the catch groove (figure 3).

Remove the magazine catch from the right side of the receiver (see figure 4).

When reinstalling the magazine catch, you will need to lightly pry the magazine catch spring toward the back of the receiver. This will allow you to get the magazine catch past the spring. To reinstall, reverse the procedure.

Extended magazine catch